More and more manufacturers are promoting these new batteries, you can find more information through the following links:
NGK insulator Chip ceramic rechargeable battery "EnerCera" series
https://www.ngk-insulators.com/cn/product/electron/enercera/
Murata Small lithium ion secondary battery
https://www.murata.com/zh-cn/products/batteries/small/
Nichicon Small lithium ion rechargeable battery
https://www.nichicon.co.jp/cn/products/slb/about/
Samples of all Torex products mentioned in this feature are available immediately, so please ask your local Torex representative for detailed information, or contact us directly through our website.
We also provide a dedicated evaluation board for testing circuits using NGK EnerCera batteries.These evaluation boards consist of two parts, one for the charging function and the other for the power supply.Customers can use power equipment to test the remaining circuits.
The power supply device has a Boost Micro DC/DC (with integrated coil) and a standard LDO installed.The layout of the optional Buck Micro DC/DC (with integrated coil) is also included.
Our standard power supply unit has 3.3V Boost Micro DC/DC and 1.8V low-power LDO, but Buck Micro DC/DC is not installed.
smallThe EMI customized version of the power supply unit can also provide customers with special voltage requirements, or if a step-down miniature DC/DC is required.
Please note that Torex does not provide batteries, but these batteries can be purchased directly from the battery manufacturer.
Torex IC is included in the table below
Charging unit |
Power supply unit |
||||
---|---|---|---|---|---|
LDO charges | XC6240A2638R-G | Low lq LDO | XC6215B182NR-G | ||
RESET IC for battery voltage monitoring |
XC6140C20A9R-G |
Boost Micro DC/DC | XCL103D333CR-G | ||
Wireless power receiver | XCM414B050D2-G | Step-down miniature DC/DC (optional) | XCL220Bxx3FR-G |
The circuits of these evaluation boards are as follows:
The evaluation board can be used for both DC and ANT inputs. However, if only the DC input is used, the Schottky barrier diode on the DC input side is not required.
The CE pin of each IC can be connected to the RESETB output of XC6140 or pulled up/down to VIN/GND
For more information on the Torex products highlighted in this article, see:
XC6140series:https : //www.torex-europe.com/products/voltage-supervisors/low-power/xc6140/
XC6215series:https : //www.torex-europe.com/products/voltage-regulators/low-iq/xc6215/
XC6240series:https : //www.torex-europe.com/products/voltage-regulators/low-iq/xc6240/
XCM414series:https: //www.torex-europe.com/products/multi-chip-modules/xcm414/
XCL103series:https: //www.torex-europe.com/products/micro-dc-dc/step-up-1/xcl103/
XCL220series:https: //www.torex-europe.com/products/micro-dc-dc/step-down-1/xcl220/